Working Principle of Cone Crusher:
Cone crusher crushes materials by the working surface between the movable cone and fixed cone. The movable cone is supported by spherical bearing and fixed on an hanging erect shaft which is set in the eccentric sleeve, and the sleeve is set on the stopping and pushing bearing. The movable cone and erect shaft are drived by the eccentric shaft sleeve together. The eccentric shaft sleeve is driven by horizontal shaft and fimbriated gear, and the wheel of the conveyor belt is drived by motor through v-belts.The lower part of vertical shaft is installed in the eccentric sleeve. When the eccentric sleeve rotates, there is a conical surface lined out by the shaft. When the movable cone comes near the fixed cone, rocks are grinded into pieces, when the cone leaves, grinded materials is discharged from the diacharge hole. The fixed cone can be ascended or descended by adjusting setting to adjust the width of discharge hole, consequantly the output size is determined.
Technical Data:
| Type |
Max. input (mm) |
Adjusting range of output (mm) |
capacity (t/h) |
Electric motor power (kw) |
weight (T) |
Overall dimensions (LхWхH)(mm) |
| PYB |
600 |
65 |
15-25 |
40 |
30 |
5 |
2800х1300х1700 |
| PYD |
35 |
3-13 |
12-23 |
5.5 |
| PYB |
900 |
115 |
15-30 |
50-90 |
55 |
10.2 |
3050х1640х2350 |
| PYZ |
60 |
5-20 |
20-65 |
10.2 |
| PYD |
40 |
3-13 |
15-50 |
10.3 |
| PYB |
1200 |
145 |
20-50 |
110-200 |
110 |
24.7 |
4000х1900х2980 |
| PYZ |
100 |
8-25 |
50-150 |
25 |
| PYD |
50 |
3-15 |
18-105 |
25.6 |
| PYB |
1750 |
215 |
25-50 |
280-480 |
160 |
50.3 |
4870х3800х4192 |
| PYZ |
185 |
10-30 |
115-320 |
50.3 |
| PYD |
85 |
5-15 |
75-230 |
50.2 |
| PYB |
2200 |
300 |
30-60 |
59-1000 |
280-260 |
80 |
5420х4300х4870 |
| PYZ |
230 |
10-30 |
200-580 |
80 |
| PYD |
100 |
7-16 |
120-340 |
81.4 |
Notice: Any change of Cone Crusher technical data shall not be advised additionally.
Tel:
